Daily Car Maintenance

Blog   2017-08-01      1,449    0

Daily car maintenance is very important. A minor effect on daily maintenance will not only cause unnecessary damage to the vehicle but also endanger the safety of the driving. On the other hand, if the daily work is done carefully, it will not only keep the vehicle new but also avoid traffic accidents. In fact, the daily maintenance work is simple, simple to say: clean, tighten, check, complement.

1. Clean
The air contains a lot of dust, sediment and acidity material, not only easy to leak fuel adhesion, easy to form solid insulation layer under the high-temperature baking, make the different performance of radiator parts, and easy to be body paint, electrostatic adsorption and erosion made the car paint oxidation.
General cleaning should not only pay attention to the cleaning of the paint but also pay attention to the cleaning of a car interior, engine, air conditioning and wheel hub. REMOVAL OF STICKERS can make this process easier.

2. After the vehicle is cleaned, tighten the joints.
The vibration, jolting, rocking of the dry line, etc., must cause the connection loose and wear. Therefore, in daily maintenance, need to tighten timely. The daily fastening of connecting parts is directly related to the safety of driving, especially the steering, braking and transmission of important components, and not to be taken lightly. Tighten the joint of the hose around the engine and leak the oil. Secondly, the connector of each line and the electrical equipment should be fastened, so as to prevent the normal operation of the electric equipment by the condition of the broken path, short circuit, and iron and so on. Once again, the main fittings are checked and tightened, such as generator transmission belt, steering linkage, transmission, and tire.
3. Check
After checking the fastening of the connecting parts, check the height and quality of the oil. The fluid will gradually lose and oxidize at high temperature, resulting in lower level and lower performance. 1. Check the battery level.
With a 5 N 6 mm diameter tube, vertical force through the charging port to the contact with the screen, with their thumb closed the top of the tube, lift pipe, measure the height of liquid column is the battery liquid level height, the standard should be 10 — 15 mm. 2. Check the oil ruler of the lubricating oil surface when it is cold. After cleaning it, insert the bottom of the oil bottom shell. After it is out, the height should be between the upper and lower line. The hot car should be extinguished when the oil is fully poured into the oil bottom. 3. Check that the coolant in the tank should be full when the height of the cooling liquid surface is full, and the level of liquid level should be between the line. The height of the liquid level should be slightly higher than the above. 4. Check the brake fluid and turn the liquid level to the level of the liquid level, and directly observe whether the liquid surface is within the specified range. 5. Check the quality of the oil and the quality of the oil.

4. Supplement
1. If there is no obvious deterioration in the oil solution during the supplementary inspection of the oil liquid, it should be found if the oil is leaking, if it should be eliminated, and the oil liquid at the same level should be replenished in time. 2. If the oil fluid changes or exceeds the replacement cycle, it should be replaced in time. Usually change the oil once every 8000km or half a year; Change the brake fluid for every 20,000 ~ 40,000km or for ~ 2 years; Use 1-2 years to replace the coolant; Change the hydraulic oil for each year or run 10,000 kilometers.

REMOVAL OF STICKERS